PRODUCT INFORMATION ; DESCRIPTION: DST 1230 is a C2TE cement-based, high-performance tile adhesive with reduced slip, extended open time and increased flexibility. AREAS OF USE •In wall and floor coverings, •In mosaic, stone, tile, granite and terracotta ceramics, •Used for thin and medium thickness laying on concrete plaster, screed wall, gypsum plasterboards, and lightweight porous concrete. •Used in Textile Membrane applications. PRODUCT FEATURES •It is an easy-to-work synthetic-modified flooring mortar horizontally and vertically. Suitable for dry and damp substrates. •Weather resistant, •High adhesion. •Easy application on floors, •Does not slip in vertical and horizontal applications, •Resistant to weather conditions •Provides Easy Adhesion, TECHNICAL SPECIFICATIONS Appearance / Color: Powder / Gray and White Application temperature: (+5 °C) – (+35 °C) Pot life: 5 hours Slip: ≤0.5 mm Open time: At least 30 min, then ≥0.5 N/mm² Initial Tensile Adhesion Strength: ≥0,1 N/Mm² After water immersion: ≥0,1 N/mm² After thermal aging: ≥0,1 N/mm² After freeze-thaw cycle: ≥ 0,1 N/mm² Temperature resistance: (-40 °C) – (+80 °C) Reaction to fire: A1 Hazardous substances: See the safety data sheet. Obtained at an air temperature of +20°C (±2ºC) and 50% ±5 relative humidity conditions. High temperatures shorten the durations, low temperatures extend them. The actually obtained values may vary due to conditions beyond our control. APPLICATION METHOD Surface Preparation: The application surface must be sound, free of anti-adhesive agents, dry, dust-free, and clean. The surface must be thoroughly cleaned of all kinds of oil, grease, rust, and paraffin residues that reduce adhesion, and there must be no loose particles on the surface. The floor to be applied must be damp, with no standing water. The use of a primer is recommended on water-absorbent surfaces and exposed concrete. If the surface temperature to be applied is above +30 °C, the surface must definitely be dampened. Mixing Pour the specified amount of clean water into a clean bucket. Empty half of the 25 Kg. DST 1230 into it and start mixing at low speed with a mixer. Add the entire remainder and mix until the mortar becomes lump-free and homogeneous, then let it rest for 5-6 min. for maturation. Then, mix for another 1-2 min. before use. Spread the adhesive over the entire surface and apply it at an uniform thickness by combing with a notched trowel. Covering materials (tiles, ceramics) are bonded onto the combed mortar within 25 min. Checking the surface flatness, ensure proper embedding and adhesion of the covering materials by tamping with a rubber mallet. Joint grouting application should be carried out at least 24 hours later. Packaging: 25 kg kraft bag. WARNINGS: Do not use material remaining in the container, past its pot life, or crusted. This material must be discarded. Prepare only as much material as you can use. Tools should be cleaned while the mortar is wet. It must be strictly protected in environments below (+) 5 °C and above (+) 35 °C. The surroundings should be covered with nylon. Precautions must be taken against frost and sudden water loss. SHELF LIFE: 12 months from the production date in its original, undamaged and unopened packaging, provided storage conditions are observed. STORAGE CONDITIONS: Store between +5°C and 30°C. Protect from frost, moisture and direct sunlight.
Your orders are shipped within 1-3 business days. Shipping is free on orders of 500 ₺ and above. You can return the product within 14 days after receiving it.
Log in, you can write a review if you have purchased this product.