DESCRIPTION: GEX 1109 is a strong, flowable, non-shrinking, ready-to-use special grout mortar containing high-performance special cement and carbonates and specially graded aggregates.
PRODUCT INFORMATION ; DESCRIPTION: GEX 1109 is a strong, flowable, non-shrinking, ready-to-use special grout mortar containing high-performance special cement and carbonates and specially graded aggregates. AREAS OF USE • For anchoring various elements such as steel structures, reinforcements, and machine foundations to concrete • In power plants, railways, bridge beams, road and bridge connections • In fixing grouting, concrete repair, and void filling. • For indoor and outdoor applications, PRODUCT FEATURES •Initial and final compressive strengths are very high, • It can enter every mold with its high fluidity property • Can be applied up to 150 mm in a single layer, •Non-shrink •Contains high-quality chemical additives, •Adheres very strongly to steel, absorbs the stresses that occur, TECHNICAL SPECIFICATIONS Material Structure: Mineral fillers, synthetic Contains additives and cement. Color: Gray Compressive strength (TS EN 12190): 1.Days ≥30 N/Mm² 7.Days ≥70 N/Mm² 28. Days ≥85 N/Mm² Flexural strength (28 days) (TS EN 196): ≥9 N/mm² Adhesion (pull-off) strength (TS EN 1542) (to concrete, 28 days): ≥2.0 N/mm² Modulus of elasticity (28 days): >20,000 N/mm² Capillary water absorption (TS EN 13057): <0.5 kg.m⁻².h⁻⁰·⁵ Application thickness: 10 mm to 150 mm Temperature of the substrate to be applied: +5°C to +30°C Service temperature: -20°C to +40°C Pot life (+20°C): 30 min. Walkable after (+20°C): 24 hours Full curing time (+20°C): 28 days Typical values: Obtained as a result of tests performed on 4x4x16 cm mortar prisms at +23°C and 50% relative humidity conditions. High temperatures shorten durations, low temperatures prolong them. APPLICATION METHOD Surface Preparation: Care must be taken to ensure that the surfaces to be applied are sound, load-bearing, dust-free and clean. They must be thoroughly cleaned of residues that would weaken adhesion, such as accumulated water, rust, metal shavings, grease and ice. In formwork applications, all formworks must have sufficient strength, formwork oil must definitely be applied and leakages must be prevented. The application surface must be saturated with water, but no free water should remain on the surface. Mixing The appropriate amount of water is poured into a clean mixing bucket with the help of a measuring scale. Half of the 25 Kg GEX 1109 is added onto the water in the bucket and mixed with a low-speed mixer for 4 minutes until a homogeneous and lump-free mixture is obtained. MIXING RATIOS GEX 1109 FOR 1 KG POWDER FOR 25 KG BAG MIXING WATER AMOUNT 0.10 lt – 0.12 lt 2.4 lt – 2.8 lt MIX DENSITY 2.30 kg/l Application Pour the prepared mortar into the application area. It must be ensured that air bubbles inside the mortar have escaped. Curing material to prevent early drying should be prevented by available or appropriate methods (such as keeping wet, covering with a wet cloth). In cold weather, use protective covers or take necessary other precautions. PACKAGING 25 kg kraft bag. CONSUMPTION 2 kg of powder product per 1 liter of mortar
Your orders are shipped within 1-3 business days. Shipping is free on orders of 500 ₺ and above. You can return the product within 14 days after receiving it.
Log in, you can write a review if you have purchased this product.