DESCRIPTION: POLYURETHANE – ENJ 304 is a low-viscosity, two-component polyurethane-based injection foam resin that contains no CFC or solvents, forms a flexible structure when cured and is activated by water.
PRODUCT INFORMATION ; DESCRIPTION: POLYURETHANE – ENJ 304 is a low-viscosity, two-component polyurethane-based injection foam resin that contains no CFC or solvents, forms a flexible structure when cured and is activated by water. AREAS OF USE; •In stopping high-pressure, pressurized and other water leaks, •In consolidating loose and unstable rock and providing waterproofing, •In crack injection and expansion joint gap filling works, •In deep injections, •In injecting tears, fissures, gravel pockets and cold joints from medium-fine to coarse size, •In tunnel construction, in membrane lining injection, •In wet or dry filling of honeycomb voids, PRODUCT FEATURES; •Non-flammable, solvent-free. •Becomes inert and chemically resistant after curing •Cures within seconds when used with a catalyst. •Becomes a flexible gasket where it is applied. •Bonds excellently to concrete, •Elastic. Does not lose its flexibility and can accommodate limited movements. APPLICATION METHOD; Surface Preparation : Care must be taken to ensure that the surfaces of the voids and cracks to be treated are sound, dust-free, and clean. Loose and friable particles must be removed from the surface. The surface must be thoroughly cleaned of all kinds of oil, rust, grease, and paraffin residues that would weaken adhesion. If there is water leakage in the area to be applied, it must be drained or sealed with a suitable plugging mortar. Mixing : After adding components A and B into the mixing container, mix for 3 minutes with a low-speed mixer (max. 250 rpm) until a homogeneous mixture is obtained. Application : After the mixing process, pour POLIÜRETAN – ENJ 304 into the hopper of the pump, mix for a short time, and start the application. Pay attention to the pot life. POINTS TO NOTE; •The product should be applied by specialists trained in this field. •Do not use less than the specified amount of components A and B. CLEANING OF TOOLS : Tools and equipment used after application must be cleaned with water. POLIÜRETAN – ENJ 303, once cured, can only be removed from the surface mechanically. PACKAGING: Component A: 20 Kg plastic drum, Component B: 1.25 Kg plastic drum STORAGE: Store in unopened original packaging in a cool, dry environment between +5 °C and +30 °C, protected from frost and direct sunlight. CONSUMPTION: Since the product is used as needed, no consumption quantity is specified. SHELF LIFE: 36 months from the production date under suitable storage conditions. For the product's technical specifications and other information, please download the TDS document. Note: If you wish to buy an individual item from the set products, you can reach us via the WhatsApp shortcut.
Your orders are shipped within 1-3 business days. Shipping is free on orders of 500 ₺ and above. You can return the product within 14 days after receiving it.
Log in, you can write a review if you have purchased this product.
DESCRIPTION: POLYURETHANE – ENJ 303 is a low-viscosity, two-component polyurethane-based injection resin that contains no CFC or solvents, forms a rigid structure when cured and is activated by water.