DESCRIPTION: KAVI 1124 is a natural-hydraulic-lime-based, cement-free, high-strength thixotropic repair and strengthening mortar developed for historic masonry structures.
PRODUCT INFORMATION ; DESCRIPTION: KAVI 1124 is a natural-hydraulic-lime-based, cement-free, high-strength thixotropic repair and strengthening mortar developed for historic masonry structures. AREAS OF USE •In repairing and strengthening masonry foundations, walls, plasters, domes, arches and vaults, •In wall joints, •In placing carbon rods, •In new foundation and wall construction, •In filling voids, PRODUCT FEATURES AND ADVANTAGES •Cement-free, •High bond strength, •High water vapor permeability, •Breathable. •Very easy to prepare and apply, •Sulfate resistant, •Asbestos-free, environmentally friendly, •High efflorescence resistance. TECHNICAL SPECIFICATIONS Composition of the Material: Pozzolanic lime, special siliceous aggregates, mineral fillers. Color: Off-white, Beige Compressive Strength: M10 (28 days) Modulus of Elasticity: 16,000 N/mm² Bond strength: ≥ 0.15 N/mm² Capillary water absorption: ≤0.2 kg.m⁻².h⁻⁰·⁵ Water Vapor Permeability: 5<20 Application thickness: 0.5-30 mm Temperature of the substrate to be applied: +5°C to +30°C Service temperature: +5°C to +40°C Pot life (+20°C): 60 min. Typical values: Obtained as a result of tests performed on 4x4x16 cm mortar prisms at +23°C and 50% relative humidity conditions. High temperatures shorten durations, low temperatures prolong them. APPLICATION METHOD Surface Preparation: Care must be taken to ensure that the surfaces to be plastered are sound, dust-free, and clean. The surface must be thoroughly cleaned of all kinds of oil, rust, grease, and paraffin residues that would weaken the adhesion. The application area must be pre-dampened to increase adhesion and improve the bonding and strength of the mortar to the surface. Mixing The appropriate amount of water is poured into a clean mixing bucket with the help of a measuring scale. KAVI 1124 is added slowly and mixed for 10 minutes with a 400-600 rpm mixer until a homogeneous and lump-free mixture is obtained. After resting for approximately 5 minutes and mixing again for 2 minutes, the material becomes ready for use. MIXING RATIOS MIXING FOR KAVI 1124 1 KG POWDER FOR 20 KG BAG WATER AMOUNT 0.25 lt – 0.30 lt 5.0 lt – 6.0 lt MIXING DENSITY 1.50 kg/m3 Application The prepared mortar is applied to the surface with a trowel at a maximum thickness of 2-3 mm. In cases where a smooth surface finish is desired, it is waited for the mortar to draw its water, and by sprinkling water on the mortar that has drawn its water using a plasterer's brush, the surface is finished with a steel or wooden trowel. Large surfaces exposed to the atmosphere, especially hot, dry or windy environments, must be protected against rapid evaporation for 24-48 hours with wet burlap, water or special curing agents. PACKAGING 20 KG KRAFT BAG CONSUMPTION 17.0 kg of powder product is required to make a plaster 1 m2 wide and 10 mm thick.
Category
Restoration Solutions › Historic Building Repair and Strengthening Mortar
Your orders are shipped within 1-3 business days. Shipping is free on orders of 500 ₺ and above. You can return the product within 14 days after receiving it.
Log in, you can write a review if you have purchased this product.
DESCRIPTION: OGH 1122 is a pozzolanic-lime-based, cement-free, high-strength thixotropic repair and strengthening mortar developed for historic masonry structures.