PRODUCT INFORMATION ; DESCRIPTION: FGS 1530 is a cement-based, high-performance, hydraulically hardening wide-joint grout. AREAS OF USE •In filling the joints of wall and floor coverings, •In ceramic claddings, •In natural and artificial stone coverings, •In handmade coverings, •In decorative brick coverings, •In concrete-based coverings, • In lime-based coverings, •In glass brick wall claddings, PRODUCT FEATURES •For joints between 5 – 20 mm, •Crack-free hardening, •Excellent adhesion, •Resistant to water and frost, •Easy and smooth to use, •Provides a smooth surface. TECHNICAL SPECIFICATIONS Conforming Standard : TS EN 13888 – CG1WA Material composition: Contains special cements, polymers and mineral fillers. Color : White and special colors Compressive strength : ( EN 12808-3) ≥15 N/mm² Compressive strength after freeze-thaw cycles (EN 12808-3): ≥15 N/mm² Flexural strength ( EN 12808-3) : ≥3,5 N/mm² Flexural strength after freeze-thaw cycle ( EN 12808-3) : ≥3,5 N/mm² Shrinkage ( EN 12808-4): ≤2 mm/m Abrasion Resistance ( EN 12808-2): ≤1000 mm³ Water Absorption 30 min: ≤2 g Water Absorption 4 hours (EN 12808: ≤ 5 g Temperature resistance: (-20°C) – (+70°C) Typical values: obtained as a result of tests performed on 4x4x16 cm mortar prisms at +23°C and 50% relative humidity conditions. High temperatures shorten the durations, low temperatures prolong them. APPLICATION METHOD Surface Preparation: Ensure that the surfaces to be applied are well adhered to the substrate and that the adhesive mortar has dried. Remove dry mortar remaining in the joint gaps. Do not start application without thoroughly cleaning all kinds of dust, cement waste, dirt, oil, etc. Make sure that the joint gaps are 2/3 of the ceramic thickness. Moisten the cleaned joint gaps before application. Fill a portion of the specified amount of water into a clean container. FGS 1530 is added slowly and mixed with a 400-600 rpm mixer for 4 minutes until a homogeneous and lump-free mixture is obtained. After resting for approximately 4 minutes and mixing again for another 2 minutes, the material is ready for use. The mortar in the container should be consumed within approximately 1 hour depending on the ambient temperature. Application The prepared mortar should be poured into the joint gaps and filled into the joints using a squeegee or a hard rubber-based joint spreading trowel. Excess mortar remaining on the surface should be scraped off with a soft-tipped spatula. Depending on the ambient temperature, after 15-30 min., the thin joint film remaining on the application surface should be wiped with a damp sponge. The cleaning sponge must be cleaned frequently. Do not start the wiping process prematurely! MIXING RATIOS FOR 1 KG POWDER FOR 25 KG BAG OF FGS 1530 MIXING WATER AMOUNT 0.25 lt – 0.30 lt 5 lt – 6 lt MIXING DENSITY 1.65 kg/lt PACKAGING In 20 kg kraft bags and 5 kg packages CONSUMPTION For consumption, see the grout consumption table. SHELF LIFE 12 months from the production date under suitable storage conditions. Opened packages must be stored under suitable conditions and used within one week.
Your orders are shipped within 1-3 business days. Shipping is free on orders of 500 ₺ and above. You can return the product within 14 days after receiving it.
Log in, you can write a review if you have purchased this product.
DESCRIPTION: TUĞ 1660 is a cement-based, high-performance, hydraulically hardening wide-joint grout developed specifically for decorative stone joints.